Novabond

Novabond, when used in a mixture of Portland cement, sand and water, then applied to clean concrete in slurry form, casts a film of acrylic-concrete over the pavement. This acrylic-concrete coating has excellent adhesive characteristics to both concrete and acrylic coatings. While the Novabond slurry coat acts as a laminating agent, and bonds the entire surfacing system together, it also fills some voids, leaving a more uniform surface to apply the Novacrylic coating system over.

Novabond can also be used as an additive to concrete mixes in place of some of the water. This addition of Novabond dramatically increases the strength and adhesion properties of the concrete, especially in patches and thin applications.

When used as the binder for a patch mix, Novabond will improve the performance of the repair.

• Novabond concrete mixes must cure 24-hours before application of Novacrylic surface system.

• DO NOT mix more than will be used in 30 minutes.

• Minimum Application Temperature is 50°F and rising.

• Novabond is not hazardous* and is free of lead, mercury, asbestos and formaldehyde.

  #040-B

PATCH AND CONCRETE SLURRY EMULSION

DILUTION: 
Slurry for concrete

2.5 gallons Novabond, 200 lb sand (50-60 mesh) plus 5 gallons water. This mix covers 1800 sq. ft. plus 1/94 lb. Bag Portland cement 

DILUTION: 
Concrete Patch

Dilute equal parts of Novabond and water. Use diluted Novabond in place of water in prepared concrete patch mix (example “Sakrete”) or in 1-part Portland cement to 2 or 3 parts sand, add liquid until desired consistency is obtained. 

DILUTION: 
Acrylic Patch mix for Asphalt Prime - Equal parts Novabond and Water

Dry mix 100 lb sand with 1.5 (20 lb) Portland cement. Add undiluted Novabond to achieve the consistency desired. For deep patches, use course sand. Very deep patches, add some small stone. Prime area prior to patching. 

COLOR

Milky white 

PACKAGED QUANTITY

5 gallon pail, 30 gallon drum, 55 gallon drum 

WEIGHT

8.9 lbs per gallon